The UCM6100 supports ring group feature with different ring strategies applied to the ring group
members. This section describes the ring group configuration on the UCM6100.
CONFIGURE RING GROUP
Ring group settings can be accessed via Web GUI->PBX->Call Features->Ring Group.
Click on "Create New Ring Group" to add ring group.
Click on
to edit the ring group. The following table shows the ring group configuration parameters.
Click on
to delete the ring group.
Ring Group Name
Extension
Ring Group Members
Ring Strategy
Permission
Firmware Version 1.0.7.11
RING GROUP
Figure 68: Ring Group
Table 49: Ring Group Parameters
Configure ring group name to identify the ring group. Letters, digits, _
and – are allowed.
Configure the ring group extension.
Select available users from the left side to the ring group member list on
the right side. Click on
Select the ring strategy. The default setting is "Ring in order".
Ring simultaneously.
Ring all the members at the same time when there is incoming call to
the ring group extension. If any of the member answers the call, it
will stop ringing.
Ring in order.
Ring the members with the order configured in ring group list. If the
first member doesn't answer the call, it will stop ringing the first
member and start ringing the second member.
Configure the permission level for Ring Group. This permission will take
effect when an incoming call is going to be directed to an external
number configured as "Default Destination". The available permissions
are "Internal", "Local", "National" and "International" from the lowest level
UCM6100 Series IP PBX User Manual
to arrange the order.
Page 147 of 233