Grandstream Networks UCM6102 User Manual page 116

Sync LDAP Enable
Sync LDAP Password
Sync LDAP Port
LDAP Outbound Rule
LDAP Dialed Prefix
Register SIP Trunk Configuration Parameters
Provider Name
Host Name
Transport
Keep Trunk CID
Disable This Trunk
TEL URI
Firmware Version 1.0.7.11
If enabled, the local UCM6100 will automatically provide and update the
local LDAP contacts to the remote UCM6100 SIP peer trunk. In order to
ensure successful synchronization, the remote UCM6100 peer also
needs to enable this option on the SIP peer trunk. The default setting is
"No".
This is the password used for LDAP contact file encryption and
decryption during the LDAP sync process. The password must be the
same on both UCM6100 peers o ensure successful synchronization.
Configure the TCP port used LDAP sync feature between two peer
UCM6100.
Specify an outbound rule for LDAP sync feature. The UCM6100 will
automatically modify the remote contacts by adding prefix parsed from
this rule.
Specify the prefix for LDAP sync feature. The UCM6100 will
automatically modify the remote contacts by adding this prefix.
Configure the provider name for the VoIP trunk. This is a unique label to
identify the trunk when listed in outbound rules, inbound rules and etc.
Configure the IP address or URL for the VoIP provider server of the
trunk.
Configure the SIP transport protocol to be used in this trunk. The default
setting is "All - UDP Primary".

UDP Only

TCP Only

TLS Only

All - UDP Primary: UDP is the primary transport protocol when all the
other SIP transport methods are available too.

All - TCP Primary: TCP is the primary transport protocol when all the
other SIP transport methods are available too.

All - TLS Primary: TLS is the primary transport protocol when all the
other SIP transport methods are available too.
When enabled, it can avoid overridden by extension's CID if the
extension has CID configured. The default setting is enabled.
If selected, the trunk will be disabled.
If the trunk has an assigned PSTN telephone number, this field should be
set to "User=Phone". Then a "User=Phone" parameter will be attached to
the Request-Line and TO header in the SIP request to indicate the E.164
number. If set to "Enable", "Tel:" will be used instead of "SIP:" in the SIP
request. The default setting is disabled.
UCM6100 Series IP PBX User Manual Page 114 of 233