Voip Trunks; Table 38: Sip Trunk Configuration Parameters - Grandstream Networks UCM6102 User Manual

VOIP TRUNKS

VoIP trunks can be configured in UCM6100 under Web GUI->PBX->Basic/Call Routes->VoIP Trunks.
Once created, the VoIP trunks will be listed with Provider Name, Type, Hostname/IP, Username and
Options to edit/detect the trunk.

Click on "Create New SIP Trunk" or "Create New IAX Trunk" to add a new VoIP trunk.

Click on to configure detailed parameters for the VoIP trunk.

Click on to configure Direct Outward Dialing (DOD) for the SIP Trunk.

Click on to start LDAP Sync.

Click on to delete the VoIP trunk.
The VoIP trunk options are listed in the table below.
Create New SIP Trunk
Type
Provider Name
Host Name
Keep Trunk CID
Disable This Trunk
TEL URI
Need Registration
Username
Password
Firmware Version 1.0.7.11

Table 38: SIP Trunk Configuration Parameters

Select the VoIP trunk type.

Peer SIP Trunk

Register SIP Trunk
Configure a unique label to identify this trunk when listed in outbound
rules, inbound rules and etc.
Configure the IP address or URL for the VoIP provider's server of the
trunk.
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
If selected, the trunk will be disabled.
If the trunk has an assigned PSTN telephone number, this field should be
set to "User=Phone". Then a "User=Phone" parameter will be attached to
the Request-Line and TO header in the SIP request to indicate the E.164
number. If set to "Enable", "Tel:" will be used instead of "SIP:" in the SIP
request. The default setting is disabled.
Select whether the trunk needs to register on the external server or not
when "Register SIP Trunk" type is selected. The default setting is No.
Enter the username to register to the trunk from the provider when
"Register SIP Trunk" type is selected.
Enter the password to register to the trunk from the provider when
"Register SIP Trunk" is selected.
UCM6100 Series IP PBX User Manual Page 111 of 233