RESET AND REBOOT
Users could perform reset and reboot under Web GUI->Maintenance->Reset and Reboot.
To factory reset the device, select the mode type first. There are two different types for reset.
User Data: All the data including voicemail, recordings, IVR Prompt, Music on Hold, CDR and backup
files will be cleared.
All: All the configurations and data will be reset to factory default.
SYSLOG
On the UCM6100, users could dump the syslog information to a remote server under Web GUI-
>Maintenance->Syslog. Enter the syslog server hostname or IP address and select the module/level for
the syslog information.
The default syslog level for all modules is "error", which is recommended in your UCM6100 settings
because it can be helpful to locate the issues when errors happen.
Some typical modules for UCM6100 functions are as follows and users can turn on "notic" and "verb"
levels besides "error" level.
pbx: This module is related to general PBX functions.
chan_sip: This module is related to SIP calls.
chan_dahdi: This module is related to analog calls (FXO/FXS).
app_meetme: This module is related to conference bridge.
Note:
Syslog is usually for debugging and troubleshooting purpose. Turning on all levels for all syslog modules
is not recommended for daily usage. Too many syslog print might cause traffic and affect system
performance.
Firmware Version 1.0.7.11
Figure 131: Reset and Reboot
UCM6100 Series IP PBX User Manual
Page 229 of 233