DEVICE CONFIGURATION
On web GUI, page PBX->Zero Config->Zero Config, users could create new device, delete existing
device(s), make special configuration for a single device, or send NOTIFY to existing device(s).
CREATE NEW DEVICE
Users could also directly create a new device and configure basic settings before the device is discovered
by the UCM6100. Once the device is plugged in, it can then be discovered and provisioned by the
UCM6100.
Click on "Create New Device" and the following dialog will show. Follow the steps below to create the
configurations for the new device.
1. Firstly select a model for the device to be created and enter its MAC address, IP address and
firmware version (optional) in the corresponding field.
2. Basic settings will show a list of settings based on the model selected in step 1. Users could assign
extensions to accounts, assign functions to Line Keys and Multiple-Purposed Keys if supported on
the selected model.
3. Click on "Create New Device" to save the configuration for this device.
Firmware Version 1.0.7.11
Figure 33: Create New Device
UCM6100 Series IP PBX User Manual
Page 76 of 233