Mac Filter - Zte ZXR10 Command Manual

Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
vlan
<vlan-id>
This example describes how to delete the MAC address
(000a.010c.e2c6) and then delete all MAC addresses on the
Ethernet port fei_1/1.
ZXR10(config)#mac delete 000a.010c.e2c6
ZXR10(config)#mac delete ethernet fei_1/1
mac add
show mac

mac filter

Use this command to to filter data frames according to the MAC
address.
Global configuration
mac filter {source | both | destination}<mac-address><vlan
-id>
source
both
destination
<mac-address>
<vlan-id>
� There is no need to specify the physical port when running the
mac filter command. The data frames on any port are filtered.
� To cancel the MAC address filtering configured by the com-
mand, run the mac delete command to delete the MAC ad-
dress.
This example describes how to filter the VLAN 1 data frames with
the MAC address 000a.010c.e2c6.
ZXR10(config)#mac filter source 000a.010c.e2c6 vlan 1
mac delete
show mac
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MAC Configuration
Delete a MAC address entry according to
some VLAN
VLAN ID where the MAC address is located
Filters data frames according to the source
MAC address.
Filters data frames according to the source or
destination MAC address
Filters data frames according to the
destination MAC address
MAC address in dotted division format
VLAN identifier, range: 1~4094
9