Name; Show Qinq - Zte ZXR10 Command Manual

Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
vlan <vlan-id>
<vlan-if>
The parameter <vlan-if> is in the format of vlan + VLAN ID, such
as vlan10.
This example describes how to create a VLAN interface vlan1, and
enter VLAN interface configuration mode.
ZXR10(config)#interface vlan 1
ZXR10(config-if)#
exit
end

name

Use this command to configure the alias of some VLAN. Restore
the default with the no form of this command.
VLAN configuration
name <vlan-name>
no name
<vlan-name>
VLAN0001 is the alias of vlan 1; VLAN0100 is the default alias of
vlan 100, and so on.
The VLAN alias cannot be the same as that of other VLAN, it must
not be configured to be the default name of any other VLANs (even
if the VLAN does not exist).
This example describes how to create vlan 2 and set its alias to v2.
ZXR10(config)#vlan 2
ZXR10(config-vlan)#name v2
show vlan

show qinq

Use this command to display information about QinQ configuration
on an interface.
All modes except user EXEC
show qinq [<interface-name>]
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 VLAN Configuration
VLAN ID, range: 1~4094
VLAN interface name
VLAN name, not more than 32 characters, it
starts with a character
23