Zte ZXR10 Command Manual page 82

ZXR10 Command Manual (Ethernet Switch Volume)
Command Modes
Syntax
Syntax
Description
Example
Related
Commands
74 Confidential and Proprietary Information of ZTE CORPORATION
form of this command. The default setting is static trunk mode
("on" mode).
Interface configuration
smartgroup mode {802.3ad | on}
no smartgroup mode
802.3ad
on
This example describes how to configure the aggregation method
of Smartgroup 10 to 802.3ad.
ZXR10(config)#interface smartgroup10
ZXR10(config-if)#smartgroup mode 802.3ad
show interface
show lacp
Indicates the aggregation control method of
the Smartgroup interface uses the 802.3ad
standard LACP.
Indicates the static trunk. LACP protocol does
not run at this time