Switchport Qinq (Global Configuration); Switchport Qinq (Port Configuration) - Zte ZXR10 Command Manual

ZXR10 Command Manual (Ethernet Switch Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
32 Confidential and Proprietary Information of ZTE CORPORATION
switchport qinq (Global
Configuration)
Use this command to configure the QinQ function for the desig-
nated port.
Global configuration
switchport <port-list> qinq {normal | uplink | customer | tpid
<tpid>}
<port-list>
normal
uplink
customer
tpid <tpid>
The port is in normal mode by default.
The QINQ attribute of the port is configured in batches. For ZXR10
3900, there is no tpid parameter in this command. For ZXR10
5900, the tpid parameter must not be modified if the port is in
normal or customer mode.
This example describes how to set ports fei_1/1–2 in uplink mode,
and the tpid to 0x9100.
ZXR10(config)#switchport fei_1/1-2 qinq uplink
ZXR10(config)#switchport fei_1/1-2 qinq tpid 0x9100
show qinq
switchport qinq (Port
Configuration)
Use this command to set the QinQ function for the port.
Interface configuration
switchport qinq {normal | uplink | customer | tpid <tpid>}
normal
uplink
Port list
Sets a port to normal
Sets a port to uplink
Sets a port to customer
Tag protocol identifier, a hexadecimal number,
range: 0x0001~0xffff, default: 0x8100
Sets a port to normal
Sets a port to uplink