Udld Recovery Enable - Zte ZXR10 Command Manual

Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
The interface UDLD protocol works in normal mode by default.
� Batch configuration only takes effect in global configuration
mode.
� When this command is used for a single interface, it takes effect
in interface configuration mode.
� This example describes how to configure the interface in ag-
gressive mode in batch in global configuration mode.
ZXR10(config)#udld mode aggressive fei_1/1-3,fei_2/1
� This example describes how to configure the interface in ag-
gressive mode in interface configuration mode.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#udld mode aggressive

udld recovery enable

Use this command to enable the function of UDLD automatic re-
covery.
Global configuration and interface configuration
udld recovery {enable | disable}<interface_range>
udld recovery {enable | disable}
enable
disable
<interface_range>
The function of UDLD automatic recovery is disabled by default.
� Batch configuration only takes effect in global configuration
mode.
� When this command is used for a single interface, it takes effect
in interface configuration mode.
� This example describes how to enable UDLD automatic recov-
ery on interfaces fei_1/1-3 and fei_2/1 in batch in global con-
figuration mode.
ZXR10(config)#udld recovery enable fei_1/1-3,fei_2/1
� This example describes how to enable UDLD automatic recov-
ery in the interface fei_1/1 in interface configuration mode.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#udld recovery enable
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 UDLD Configuration
enables the function of UDLD automatic
recovery
disables the function of UDLD automatic
recovery
Interface name range, at most 16 interfaces
can be configured once
81