Set Ethernet-Oam Port Link-Monitor Frame; Set Ethernet-Oam Remote-Loopback Start - Zte ZXR10 Command Manual

ZXR10 Command Manual (Ethernet Switch Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
90 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#set ethernet-oam period 5 timeout 6 mode active
set ethernet-oam port
link-monitor frame
Use this command to configure port error symbol frame link event
parameters.
Interface Configuration
set ethernet-oam port <port-list> link-monitor frame thres
hold <xxx> window <yyy>
<xxx>
<yyy>
To view this configuration, use the show running-config com-
mand in global configuration mode.
At present fei and gei interfaces are supported, while sg interfaces
are not supported.
This example describes how to configure Ethernet link OAM inter-
face error symbol frame event parameters in interface configura-
tion mode.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#set ethernet-oam link-monitor frame
threshold 30 window 10
set ethernet-oam
remote-loopback start
Use this command to enable or disable link Ethernet OAM remote
loopback.
Interface Configuration
set ethernet-oam remote-loopback { start | stop }
start
stop
To view this configuration, use the show running-config com-
mand in global configuration mode.
Error frame, range: 1~65535, default: 1
Period statistics time, in seconds, range:
1~60, default: 1 second
Enables link Ethernet OAM remote loopback.
Disables link Ethernet OAM remote loopback.