Mac Protect Time; Mac To-Static - Zte ZXR10 Command Manual

ZXR10 Command Manual (Ethernet Switch Volume)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
12 Confidential and Proprietary Information of ZTE CORPORATION
learning is set, the protection time if the MAC address learning on
the interface is in abnormal status and the number of the MAC
addresses that the port can learn need setting.
ZXR10 T160G only supports the configuration of protection state
on the physical interface.
This example describes how to configure the Ethernet interface
fei_1/1 to protect the MAC address learning.
ZXR10(config)#mac protect ethernet fei_1/1 enable
mac limit-num

mac protect time

show mac protect

mac protect time

Use this command to configure the protection time when the MAC
address learning on the interface is in abnormal status.
Global configuration
mac protect time <time>
<time>
� Only one protection time can be set for the whole switch.
� The command will not be effective until the mac protect com-
mand is configured.
This example describes how to set the number of the MAC ad-
dresses that the Ethernet interface fei_1/1 can learn to 1000, and
configure this interface to protect the MAC address learning. And
the protection time is 500 seconds.
ZXR10(config)#mac limit-num ethernet fei_1/1 1000
ZXR10(config)#mac protect
ZXR10(config)#mac protect time 500
mac limit-num
mac protect
show mac protect
show mac running

mac to-static

Use this command to translate all dynamic MAC addresses learned
by the interface into static MAC addresses.
Global configuration
Protection time of the MAC address learning,
in seconds, range: 0~3600
ethernet fei_1/1 enable