Vlan Qinq - Zte ZXR10 Command Manual

Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
vlan protocol-map {enable | disable}
enable
disable
This function is enabled by default.
The platform version 4.6.02 and upgrade versions support this
command.
This example describes how to enable the protocol-based VLAN
division on the interface fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-vlan)#vlan protocol-map enable
show vlan protocol-map

vlan qinq

Use this command to set the Selective VLAN (SVLAN) rule. Delete
the setting with the no form of this command.
Global configuration
The command format on ZXR10 T240G/T160G:
vlan qinq session-no <session_id> customer-port <interface
-name> uplink-port <interface-name> in-vlan <vlan-list>{ov
lan {<vlanId>|<name>}[priority {<priority-list>| mapping}]|
untag}
no vlan qinq session-no {<session_id>| all}
The command format on ZXR10 3900:
vlan qinq session-no <session_id> customer-port <interface
-name> uplink-port <interface-name> in-vlan <vlan-list>{[ov
lan {<vlanId>|<name>} customerbrg-port <interface-name>
uplinkbrg-port <interface-name>[mapping]]| untag}
no vlan qinq session-no {<session_id>| all}
The command format on ZXR10 5900:
vlan qinq session-no <session_id> customer-port <interface
-name> uplink-port <interface-name> in-vlan <vlan-list>{ov
lan {<vlanId>|<name>}[priority <priority-list>]| untag}
no vlan qinq session-no <session_id>
For ZXR10 T160G:
<session_id>
customer-port
<interface-name>
uplink-port
<interface-name>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 VLAN Configuration
Enables this function on the interface
Disables this function on the interface
Session ID, range: 1~1000
Customer port
Uplink port
39