Smartgroup - Zte ZXR10 Command Manual

ZXR10 Command Manual (Ethernet Switch Volume)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
72 Confidential and Proprietary Information of ZTE CORPORATION
neighbors
sys-id
This example describes how to display the aggregation status of
the member interface in a Smatgroup.
ZXR10(config)#show lacp internal

Smartgroup:2

Actor Agg LACPDUs Port
Port State Interval Priority Key State Machine Machine
---------------------------------------------------------------
fei_3/17 selected 30
fei_3/18 selected 30

smartgroup

smartgroup
Use this command to add an interface to a link aggregation group,
and set the link aggregation mode for the interface. Remove the
interface from the link aggregation group with the no form of this
command.
Interface configuration
smartgroup <smartgroup-id> mode {passive | active | on}
no smartgroup
<smartgroup-id>
passive
active
on
� The aggregation mode of a member interface must be consis-
tent with that of the Smatgroup interface. Otherwise such an
interface is not allowed to join the Smatgroup.
� VLAN configurations of a member interface must be consistent
with those of the Smatgroup. Otherwise such an interface is
not allowed to join the Smatgroup.
� After an interface joins an aggregation group, you may modify
the VLAN attribute of the Smatgroup. The member interface
automatically modifies the VLAN attributes to keep consistent
with that of the Smatgroup.
This example describes how to add the interface gei_3/1 to Smat-
group 10.
Shows the member interface status of the
peer neighbor
Shows the LACP system priority
Oper Port RX
32768 0x202 0x3d current distributing
32768 0x202 0x3d current distributing
Link aggregation group ID, in the range of
1~32
Sets the interface LACP to passive negotiation
mode
Sets the interface LACP to active negotiation
mode
Indicates the static trunk mode when LACP
is disabled and the two extremities of the
aggregation must be set to on mode
Mux