Spanning-Tree Path-Cost - Zte ZXR10 Command Manual

ZXR10 Command Manual (Ethernet Switch Volume)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
68 Confidential and Proprietary Information of ZTE CORPORATION
This example describes how to set the BPDU packet type of the
interface fei_3/1 to CISCO.
ZXR10(config-if)#spanning-tree packet-type cisco
spanning-tree link-type
spanning-tree edged-port

spanning-tree path-cost

Use this command to set the path cost of the interface.
Interface configuration
spanning-tree instance <ins-index> path-cost <cost>
<ins-index>
<cost>
The path cost of the interface is set according to the port rate-path
cost mapping table.
� The platform version 4.6.02 and upgrade versions support this
command.
� With this command configured, the administrator can change
the STP topology.
This example describes how to set the path cost of the interface
fei_3/1 to 30000.
ZXR10(config)#interface fei_3/1
ZXR10(config-if)#spanning-tree path-cost 30000
spanning-tree mst instance (port configuration)
Instance number to which the interface
belongs, range: 0~63
Path cost of the interface, range: 1~2000000