Lacp Configuration; Clear Lacp; Interface - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
6
C h a p t e r

LACP Configuration

Table of Contents
clear lacp .........................................................................69
interface ..........................................................................69
lacp port-priority ...............................................................70
lacp system-priority ...........................................................70
lacp timeout .....................................................................71
show lacp .........................................................................71
smartgroup ......................................................................72
smartgroup load-balance ....................................................73
smartgroup mode ..............................................................73

clear lacp

Use this command to clear the count of received and transmitted
LACP packets.
Privileged EXEC
clear lacp [<smartgroup-id>] counters
<smartgroup-id>
The count of all Smartgroup interfaces is cleared when the param-
eter <smartgroup-id> is not configured.
This example describes how to clear the count of the Smartgroup1

interface.

ZXR10#clear lacp 1 counters

interface

Use this command to create a VLAN interface and enter VLAN in-
terface configuration mode. Remove the VLAN interface with the
no form of this command.
Global configuration
interface {vlan <vlan-id>|<vlan-if>}
Confidential and Proprietary Information of ZTE CORPORATION
Link aggregation group identifier, range:
1~32
69