Lacp Timeout; Show Lacp - Zte ZXR10 Command Manual

Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
This example describes how to set the LACP system priority.
ZXR10(config)#lacp system-priority 100

show lacp

lacp timeout

Use this command to set the LACP timeout on the interface.
Interface configuration
lacp timeout {long | short}
long
short
Long timeout
� When the long timeout is set, the system sends LACP packets
every 30 seconds.
�
When the short timeout is set, the system sends LACP packets
every 1 second.
This example describes how to set the interface LACP to short time-
out.
ZXR10(config)#interface fei_2/1
ZXR10(config-if)#lacp timeout short

show lacp

show lacp
Use this command to display information about the current LACP
configuration and status.
All modes except user EXEC
show lacp {[<smartgroup-id>]{counters | internal | neighbo
rs}| sys-id}
<smartgroup-id>
counters
internal
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 6 LACP Configuration
Sets the interface LACP to long timeout
Sets the interface LACP to short timeout
Link aggregation group ID, in the range of
1~32
Shows the LACP packets received/sent on the
interface
Shows the aggregation status of the member
interface
71