Spanning-Tree Mst Max-Hops; Spanning-Tree Packet-Type - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
spanning-tree mst instance (global configuration)

spanning-tree mst max-hops

Use this command to set the maximum hops of the BPDU packet in
the MST area. Restore default with the no form of this command.
Global configuration
spanning-tree mst max-hops <hop>
no spanning-tree mst max-hops
<hop>
� The platform version 4.6.02 and upgrade versions support this
command.
� All the non 0 instances in the MST area use the maximum hops
to determine the hops of the BPDU packet.
This example describes how to set the max-hops to 23.
ZXR10(config)#spanning-tree mst max-hops 23
spanning-tree max-age

spanning-tree packet-type

Use this command to set the BPDU packet type of the STP port.
Interface configuration
spanning-tree packet-type {IEEE | CISCO | HUAWEI | HAMM
ER}
no spanning-tree packet-type
IEEE
CISCO
HAMMER
HUAWEI
The port BPDU packet type is IEEE by default.
� The platform version 4.6.02 and upgrade versions support this
command.
� Because different manufacturers modify MSTP packets, user
must configure the BPDU packet type of the port for MSTP con-
nection to devices of the above manufacturers.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 STP Configuration
Maximum hops of the BPDU packet, in the
range of 1~40 , default: 20 seconds
Standard IEEE BPDU packet
CISCO BPDU packet
HAMMER (Harbour Networks) BPDU packet
HUAWEI BPDU packet
67