Show Mac - Zte ZXR10 Command Manual

Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Example
interface <port-na
me>
disable
enable
This command is used to control the port to filter the traffic ac-
cording to the unknown source MAC.
This example describes how to configure the unknown source MAC
address filter on the interface.
ZXR10(config)#mac unknowsource-filter interface gei_1/1 enable

show mac

show mac

Use this command to display the MAC address entry.
All modes
show mac [dynamic | static | permanent | to-static | src-f
ilter | dst-filter | <mac-address>[vlan <vlan-id>] | interface
<port-name>| vlan <vlan-id>]
dynamic
static
permanent
to-static
src-filter
dst-filter
<mac-address>
interface <port-na
me>
vlan <vlan-id>
This example describes how to display all MAC addresses on the
Ethernet interface fei_1/1. (In this example, it is displayed on
ZXR10 T160G , which slightly differs from ZXR10 3900/3200 and
ZXR10 5900/5200).
ZXR10(config)#show mac Ethernet fei_1/1
Total MAC address : 2
Flags:vid --VLAN id,stc--static,per--permanent,toS--to-static,
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MAC Configuration
Ethernet physical port
Disables the filtering of unknown source MAC
traffic
Enables the filtering unknown source MAC
traffic
Dynamic address
Static address
Permanent address
Solidified MAC address
Filters data frames according to the source
MAC address
Filters data frames according to the
destination MAC address
MAC address in dotted division format
Ethernet physical port
VLAN ID, range: 1~4094
15