Snmp-Server Traps Link-Status - TP-Link T2500G-10TS Cli Reference Manual

disable the sending of SNMP standard traps, please use no snmp-server
traps snmp command.
Syntax
snmp-server traps snmp [ linkup | linkdown | warmstart | coldstart |
auth-failure ]
no snmp-server traps snmp [ linkup | linkdown | warmstart | coldstart |
auth-failure ]
Parameter
linkup —— Enable linkup trap. It is sent when port status changes from
linkdown to linkup. By default, it is enabled.
linkdown ——Enable linkdown trap. It is sent when port status changes from
linkup to linkdown. By default, it is enabled.
warmstart —— Enable warmstart trap. It is sent upon SNMP function reboot.
By default, it is enabled.
coldstart —— Enable coldstart trap. It is sent upon switch reboot. By default,
it is enabled.
auth-failure —— Enable the auth-failure trap. It is sent when a received SNMP
request fails the authentication. By default, it is enabled.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enable SNMP standard linkup trap for the switch:
T2500G-10TS(config)# snmp-server traps snmp linkup
33.9

snmp-server traps link-status

Description
The snmp-server traps link-status command is used to enable SNMP link
status trap for the specified port. To disable the sending of SNMP link status
trap, please use no snmp-server traps link-status command.
Syntax
snmp-server traps link-status
no snmp-server traps link-status
296