Logging File Flash Level - TP-Link T2500G-10TS Cli Reference Manual

Parameter
periodic
buffer to the flash, ranging from 1 to 48 hours. By default, the synchronization
process takes place every 24 hours.
immediate —— The system log file in the buffer will be synchronized to the
flash immediately. This option will reduce the life of the flash and is not
recommended.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify the log file synchronization frequency as 10 hours:
T2500G-10TS(config)#logging file flash frequency periodic10
18.4

logging file flash level

Description
The logging file flash level command is used to specify the system log
message severity level. Messages will a severity level equal to or higher than
this value will be stored to the flash. To restore to the default level, please use
no logging file flash level command.
Syntax
logging file flash level
no logging file flash level
Parameter
level
marked with values 0-7. The smaller value has the higher priority. Only the log
with the same or smaller severity level value will be saved to the flash. By
default, it is 2 indicating that the log message marked with 0~2 will be saved
in the log flash.
Command Mode
Global Configuration Mode
—— The frequency to synchronize the system log file in the log
level
—— Severity level of the log message. There are 8 severity levels
134