Table of Contents
Advertisement
5/6 - Manual Call
The Manual Call option is used to establish a manual PPP call to a configured remote site.
Enter :
remote site id or alias to dial (1 to 16 characters)
>
Note: This option will only appear if an ISDN BRI interface module is installed which does not have the digital leased line
option enabled.
6/7 - Force Disconnect
The Force Disconnect option will cause the chosen remote site connection to be disconnected.
Enter :
remote site id or alias to disconnect
>
Edit Remote Site Menu
Option
1. Connection set-up
2. Protocol set-up
3. Remote site alias
4. Connection
5. Primary connection
6. Remote site type
Enter:
Remote site id or alias (1 to 16 characters)
>
The above display is the first level of the EDIT REMOTE SITE MENU. Enter the ID number or alias of the site you wish
to edit.
Note: the options on this menu are not active until the Remote Site ID is entered.
When creating a new remote site profile, an alias must be entered for the new site. The first available identifier number will be
assigned to this alias. The alias may be up to 16 characters long; blank spaces and the character "!" may not be used and the
alias must start with a letter of the alphabet. You will then be prompted to enter a Template id number or profile; if this
remote site will have a profile similar to an existing site, entering the alias or id number of that site will copy that remote site
profile to this one. If you wish to start from the default settings, enter "none" (case sensitive).
Menus Reference Manual: Remote Site Set-Up Menu
EDIT REMOTE SITE MENU
Value
menu
menu
*[
*[
*[
*[
Description
- Configure connections
- Configure protocols
]
- Alias of remote site entry
]
- Select connection configuration
]
- Select connection type
]
- Interoperable or spoofing
69
Advertisement
Table of Contents
