Black Box 5000 series Reference Manual page 109

Menus Reference Manual: Edit Remote Site - IPX Parameters Menu
The following three options appear only if the Link IPX Type option is set to numbered:
3 - IPX Net
The IPX Net option allows the definition of the IPX network number to use for the WAN connection when operating
in numbered mode for this IPXCP link to the remote site PPP router.
Default: [none]
Enter :
none, Network number (up to 8 characters)
>
4 - Local IPX Node
The Local IPX Node option allows the definition of an Internet Packet Exchange (IPX) node address for the link of
this router.
When the link IPX type is set to unnumbered, the Local IPX Node option is not available.
The IPX Node address consists of 12 hexadecimal bytes. The address may be entered with or without the hyphens. An
example of an IPX node address may be 00-00-d0-00-12-13, and would be entered as such or simply as 0000d0001213.
Default: [none]
Enter :
none, IPX node number (up to 17 characters)
>
5 - Peer IPX Node
The Peer IPX Node option allows the definition of an Internet Packet Exchange (IPX) node address for the link side of
the PPP IPX router at the remote site.
When the link IPX type is set to unnumbered, the Peer IPX Node option is not available.
Default: [none]
Enter :
none, IPX node number (up to 17 characters)
>
3 / 6 - Static Routes Only
The Static Routes Only option determines the type of IPX routing to perform on the connection with the peer IPX
router. By enabling this option, only the static IPX routes and services defined in the IPX Routing Set-up menu will be
used to perform IPX routing with the peer IPX router.
Default: [disabled]
109