Table of Contents
Advertisement
Menus Reference Manual: Advanced PPP Set-Up Menu
4 - Quality Protocol
The Quality Protocol option determines if this P1700 will request Link Quality Protocol monitoring on the PPP link.
Default:
[disabled]
5 - Quality Interval
The Quality Interval option specifies the time interval between Link Quality Report packets that are generated and sent
to the peer PPP router.
Default:
[10 sec]
Range:
1 to 60 seconds
6 - MP Encapsulation
The MP Encapsulation option when set to enabled, specifies that the NCP negotiation messages are encapsulated within
the Multilink header. When set to disabled, the NCP messages are not encapsulated within the Multilink frames.
Default:
[enabled]
7 - MP Sequencing
The MP Sequencing option specifies the size of the Multilink sequencing number used in the Multilink header during
frame transmission. A setting of normal will use a 4 byte sequencing number and a setting of short will use a 2 byte
sequencing number.
Default:
[normal]
Choices:
normal, short
Considerations:
When connecting to a Combinet PPP device, the MP Sequencing should always be set to short.
8 - MP Discriminator
The MP Discriminator option specifies the type of identification used to identify this P1700 during a Multilink
connection. The MP Discriminator allows the remote site PPP router to uniquely identify this Multilink link when it
requests establishment.
Default:
[MAC_address]
Choices:
MAC_address, IP_address, directory_number
9 - MP Minimum
The MP Minimum option specifies the minimum size of PPP frame that will not be fragmented when sent to the remote
site PPP router. PPP frames equal or larger than this value will be fragmented across the links in a Multilink connection.
A value of zero causes all inter-router frames to be fragmented.
Default:
[50]
Range:
0 to 1600
128
Advertisement
Table of Contents
