Table of Contents
Advertisement
Throughout this manual, information that is presented by the router and entered into the router will be shown in a bordered
box, as shown here.
Screen information being displayed or entered.
Initial Router & Management Console Power-Up
The following screen information will be seen on the console connected to the router when it is first powered on:
Terminals supported:
teletype ansi, avt, ibm3101, qvt109, qvt102, qvt119, tvi925, tvi950,
vt52,vt100, wyse-50, wyse-vp
Enter terminal type:
As the terminal type is not yet defined at the very first power-up, this screen may be slightly mixed up. Enter at least one
<RETURN> (up to three if necessary) on the Network Console in order for the router to determine the baud rate of the
terminal used for the console (i.e. auto-baud) and then proceed.
Select your terminal if listed and enter its name in lower case at the prompt, or choose the terminal type teletype if your
terminal is not listed. The teletype terminal type operates in scroll mode and may be used successfully until a custom
terminal definition is created.
Menu Command Entry
Once the terminal type is specified, the MAIN (LOGIN) MENU will be displayed.
The router uses a "hotkey " Menu. A menu option is chosen by selection of the desired option number.
Entry of parameters is from the ">" prompt. When a parameter is required, enter the necessary string and end it with a
<Return>. If the entry is not accepted, an error message will be reported and the parameter will have to be re-entered.
Should you make an error, the <BACKSPACE> key (for most terminals) deletes the most recently entered characters.
PPP Menus
2
Advertisement
Table of Contents
