Table of Contents
Advertisement
Menus Reference Manual: Bridge Pattern Filter Menu
5 - Add Pattern
The Add Pattern option allows the definition of a filter mask and adds it to the filter table. Filter masks are checked against
the frame in the order of their index numbers, so those that are most likely to be encountered should have the lowest index numbers.
Enter:
global, lan, Remote site id or alias
>
Enter:
filter pattern (up to 80 characters)
> 12-600x
Enter:
pattern ID number (from 1 to 64)
> 1
A global filter pattern will be applied to all bridge data.
A lan filter pattern will be applied to all bridge data being sent to the local LAN.
A Remote Site Id or Alias filter pattern will be applied to all bridge data being sent to the specified remote site
only. The Remote Site Alias specified must be defined on this device.
6 - Remove Pattern
The Remove Pattern option deletes a previously created filter mask (in this case, a filter mask with the pattern ID of "2").
(Confirm the removal with Show Pattern).
Enter:
all, pattern ID number
>2
7 - Help
The Help option provides Help screens describing the creation of Filter Masks.
To move between the Help screens, type: [s]tart, [n]ext, or [p]rev. (You must use lower-case letters)
206
Advertisement
Table of Contents
