Table of Contents
Advertisement
7 - TFTP Access
The TFTP Access option determines whether a remote LAN device will be allowed to make a TFTP connection to this
router to dump (get) or restore (put) the configuration.
The TFTP application must be in "netascii" or "ascii" mode for configuration transfers.
Default: [disabled]
Procedures for performing a Configuration Dump using TFTP:
1)
Start the TFTP application to be used for transfers to the router.
(The IP address of the router may be found in the Internet Set-Up menu.)
2)
Get the file "config.txt" from the router.
3)
Use a text editor to check the configuration file saved to the PC disk to confirm that the information is still in
order. If minor errors occurred, they may be corrected with the text editor. If errors were major, get the
configuration file again.
Procedures for performing a Configuration Load using TFTP:
1)
Start the TFTP application to be used for transfers to the router.
(The IP address of the router may be found in the Internet Set-Up menu.)
2)
Put the file "config.txt" to the router.
3)
When the transfer is complete, the configuration will have been restored to the router.
Menus Reference Manual: Access Set-Up Menu
12
Advertisement
Table of Contents
