Table of Contents
Advertisement
3 - Configure Count
The Configure Count option specifies the number of Configure Request packets that will be sent without receiving a
valid Configure Ack, Configure Nak, or Configure Reject packet. If a valid response packet is not received within the
count specified, it is assumed that the peer PPP router is unable to respond.
Default:
[10]
Range:
1 to 100
4 - Failure Count
The Failure Count option specifies the number of Configure Nak packets that will be sent without sending a Configure
Ack before assuming that the configurations requested are not converging. A Configure Nak packet is sent when one of
the PPP routers wishes to negotiate the particular LCP parameter to be a different value than the one proposed by the
initiating PPP router.
Default:
[5]
Range:
1 to 100
5 - Terminate Count
The Terminate Count option specifies the number of Terminate Request packets that will be sent without receiving a
Terminate Ack before assuming that the peer PPP router is unable to respond.
Default:
[2]
Range:
1 to 10
Menus Reference Manual: PPP Set-Up Menu
126
Advertisement
Table of Contents
