Table of Contents
Advertisement
Network Forward delay
Network Max age
Network Hello time
Bridge Forward delay
Bridge Max age
Bridge Hello time
*
These parameters are defined at each bridge with Options 4, 5, and 6.
** These parameters are defined by the Root bridge.
*** If this bridge is the Root bridge, corresponding parameters will be the same. If it is not the Root Bridge,
these values may differ. (It is very possible that these values can be the same if this is not the Root
Bridge, since these are the values recommended by the IEEE 802.1D standard. Check and compare the
Bridge ID to the Root ID for confirmation of the Root.)
7 - Show Ports
The Show Ports option displays the status of this bridge's STP ports.
Port Status Summary
Name
---------------- -------- --- --- ----- ------------ ----- --- --- -----
LAN
SITE2
Name
The Name column shows either the name of the STP port. LAN for the local LAN, or the remote site profile
alias name for a properly connected remote site device.
State
The State column indicates the current port states that may be Disabled (by management action); or either
Listen(ing), Learn(ing), Forward(ing) or Block(ing) (by STP action).
ID
In the above display, there are two indicators of the LAN port identifying numbers. They are found under the
ID columns. They may not fall in order, as the listing is based on the MAC address of each bridge.
Cost
The Cost columns indicate the contributing cost of each port's path to the Root Path Cost.
Menus Reference Manual: Spanning Tree Menu
: 15 seconds **
: 20 seconds **
: 2 seconds **
: 15 seconds *
: 20 seconds *
: 2 seconds *
State
Id Pri
Forward
1 128 100
Forward
44 128 100
***
Designated
Bridge
Cost
Address
Self
020304050607 32768
175
Designated
Port
Pri
Id Pri
Cost
Self
44 128
0
Advertisement
Table of Contents
