Table of Contents
Advertisement
2 - IP Address Connect
The IP Address Connect option enables or disables the IP Address connect operation of the router. When IP Address
Connect is enabled, all IP traffic on the local LAN is checked against the IP routing table. If the IP address is not
present in the IP routing table, the address is checked in the IP Address Connect table.
Default:
[disabled]
3 - Show IP Address Entries
The Show IP Address Entries option displays all of the IP addresses and their corresponding remote site profile alias
currently in the IP Address connect table. There may be up to 128 IP network addresses defined in the table.
ID
IP Address
--
---------------
1
12.12.12.12
Type: [s] to redraw, [=] main menu, any other key to end.
note: the [s] to redraw is case sensative; it must be lower case.
ID:
IP Address:
Subnet Mask Size:
Subnet Mask:
Remote Site:
4 - Remove IP Address Entry
The Remove IP Address Entry option allows you to remove a selected IP Address Connect entry from the database.
The entries may be removed individually by using the index number or all at once.
Enter :
all, id
>
Menus Reference Manual: IP Address Connect Menu
Subnet Mask Size
----------------
Entry number in the IP Address Connect table.
Network IP address of the remote network or device.
IP address mask size defined
IP address mask created from the mask size defined. The mask is used to allow all IP
addresses of a destination IP network to apply to the Address connect function.
Remote site profile entry to be used to call a remote partner router when IP traffic
destined for the IP address is seen on the local LAN.
Subnet Mask
---------------
1
128.0.0.0
130
Remote Site
----------------
Vancouver
Advertisement
Table of Contents
