Universal Setup Menu - Konica Minolta Bizhub 4020 User Manual

Universal Setup menu

Use
Units of Measure
Inches
Millimeters
Portrait Width
3–8.5 inches
76–216 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge
User's Guide
To
Identify the units of measure.
Note: Millimeters is the factory default setting.
Set the portrait width.
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• You can increase the width in 0.01-inch increments.
• 216 mm is the factory default setting. You can increase the width
in 1-mm increments.
Set the portrait height.
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• You can increase the height in 0.01-inch increments.
• 356 mm is the factory default setting. You can increase the height
in 1-mm increments.
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
- 157 -