Setting Up The Paper Sources ("Paper Source Setup" Menu) - Konica Minolta 7115F Instruction Manual

Initial Set Mode – Copy Functions
9.2 Setting Up the Paper Sources ("PAPER SOURCE
SETUP" Menu)
From the "PAPER SOURCE SETUP" menu, various functions for the
paper trays can be set.
"PAPER SOURCE SETUP" menu:
No. PAPER SOURCE
SETUP
1 INCH/METRIC
2 TRAY1 PAPER
3 AUTO SELECT
Konica 7115F/7118F
Description
This function can be used to set the size measurement
system for the paper loaded in each tray. It can be used to
select whether paper measured in centimeters such as A4
and B5 sizes ("METRIC") or paper measured in inches
("INCH") such as Letter size is loaded. If no particular setting
is selected, the paper size is detected automatically.
• The manufacturer's default setting is "METRIC".
This function can be used to set the type of paper (plain
paper, OHP transparencies or postcards) loaded into the 1st
Tray, and whether the size is automatically detected (AUTO)
or specified (SIZE INPUT).
• The manufacturer's default settings are "PLAIN" and
"AUTO".
Since all trays are normally available for automatic paper
selection, special paper loaded into a tray may be
automatically selected and wrongly copied onto.
For this reason, if this function is used to set the tray to
"DISABLE", the paper in that tray will not be available for
automatic paper selection. In addition, it will not be available
for automatic paper source selection.
"ENABLE": Paper and tray can be automatically selected.
"DISABLE" & "CONTINUOUS": Paper cannot be
automatically selected, but tray can be automatically
selected.
"DISABLE" & "FIXED": Paper and tray cannot be
automatically selected.
• The manufacturer's default setting is "ENABLE".
9
9-11