Konica Minolta Bizhub 4020 User Manual page 168

Use
USB Buffer
Disabled
Auto
3K to [maximum size
allowed]
Job Buffering
Off
On
Auto
Mac Binary PS
On
Off
Auto
ENA Address
yyy.yyy.yyy.yyy
ENA Netmask
yyy.yyy.yyy.yyy
User's Guide
To
Set the size of the USB input buffer.
Notes:
• Auto is the factory default setting.
• Disabled turns off job buffering. Any jobs already buffered on the printer
hard disk are printed before normal processing resumes.
• The USB buffer size value can be changed in 1-K increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buffers, and whether Resource Save is set
to On or Off.
• To increase the maximum size range for the USB Buffer, disable or reduce
the size of the parallel, serial, and network buffers.
• The printer automatically restarts when the setting is changed from the
printer control panel. The menu selection is then updated.
Temporarily store print jobs in the printer hard disk before printing.
Notes:
• Off is the factory default setting.
• On buffers jobs on the printer hard disk.
• Auto buffers print jobs only if the printer is busy processing data from
another input port.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• Auto is the factory default setting.
• On processes raw binary PostScript print jobs.
• Off filters print jobs using the standard protocol.
Set the network address information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
Set the netmask information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
- 168 -