Cli: Viewing Port Status And Configuring Port Parameters - HP procurve series 4100gl Management And Configuration Manual

Optimizing Traffic Flow with Port Controls, Port Trunking, and Port-Based Priority
Viewing Port Status and Configuring Port Parameters
9-6
Figure 9-2. Example of Port/Trunk Settings with a Trunk Group Configured
[E]
(for Edit). The cursor moves to the Enabled field for the first port.
2. Press
3. Refer to the online help provided with this screen for further information
on configuration options for these features.
4. When you have finished making changes to the above parameters, press
[S]
, then press
[Enter]
CLI: Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Commands
show interfaces brief
show interface config
interface
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Using the CLI To View Port Status. Use the following commands to dis-
play port status and configuration:
show interfaces brief: Lists the full status and configuration for all ports
I
on the switch.
show interface config: Lists a subset of the data shown by the show
I
interfaces command (above); that is, only the enabled/disabled, mode, and
flow control status for all ports on the switch.
(for Save).
below
page 9-7
page 9-8