Toshiba TOSVERT VF-S11 Instruction Manual page 85

[Example of how to adjustment the FM terminal frequency meter]
* Use the meter's adjustment screw to pre-adjust zero-point.
Key operated
MODE
5
MODE
Adjusting the meter in inverter stop state
If, when adjusting the meter for output current, there are large fluctuations in data during adjustment, making
adjustment difficult, the meter can be adjusted in inverter stop state.
When setting
put (inverter's rated current = 100%). In this state, adjust the meter with the
ter.
Similarly, if you set
half the inverter's rated current is flowing will be output through the FM terminal.
After meter adjustment is ended, set
LED display
- .
.
.
MODE
+ .
to for fixed output 1 (100% output current), a signal of absolute values will be out-
to
Displays the operation frequency.
(When standard monitor display selection
frequency])
The first basic parameter "
Press either the or the key to select "
Press the ENTER key to display the operation frequency
Press either the key or the
The meter reading will change at this time but be careful because there
will be no change in the inverter's digital LED (monitor) indication.
The adjustment is complete.
nately.
The display returns to its original indications.
(When standard monitor display selection
frequency])
for fixed output 2 (output current at 50%), a signal that is sent out when
to (output current).
E-12
Operation
is set to
" (history function) is displayed.
".
key to adjust the meter.
[Hint]
It's easier to make the adjustment if you
push and hold for several seconds.
and the frequency are displayed alter-
is set to
(Meter adjustment) parame-
E6581158
[Operation
[Operation