Toshiba TOSVERT VF-S11 Instruction Manual page 119

Parameter setting
Title
Frequency setting mode selection 1
Frequency priority selection
Speed setting mode selection 2
1) External switching (Input terminal function 38 : FCHG enabled)
Frequency priority selection parameter
Switching between the command specified with
from a terminal board.
To do so, however, the frequency command forced switching function (input terminal function selection: 38)
needs to be set beforehand to an input terminal board.
If an OFF command is entered to the input terminal board: The command specified with
selected.
If an ON command is entered to the input terminal board: The command specified with
selected.
2) Automatic switching by frequency command
Frequency priority selection parameter
The switching between the command specified with
the frequency command entered.
If the frequency set with
If the frequency set with
Function
0: Built-in potentiometer
1: VIA/II
2: VIB
3: Operation panel
4: Serial communication
5: UP/DOWN from external
contact
6: VIA + VIB (Override)
0:
by the input terminal)
1:
quencies equal to or lower than
1.0 Hz)
0: Built-in potentiometer
1: VIA
2: VIB
3: Operation panel
4: Serial communication
5: UP/DOWN from external
contact
6: VIA + VIB (Override)
=
and
=
is above 1Hz: The command specified with
is 1Hz or less: The command specified with
F-17
Adjustment range
(Switchable to
( for output fre-
can be made by entering a command
and is done automatically according to
will be selected.
will be selected.
E6581158
Default setting
0
0
1
6
will be
will be