Toshiba TOSVERT VF-S11 Instruction Manual page 110

• Function
Setting of contact input terminal function
Terminal
symbol
6
Only when
valid.
Note 1: The function that has been selected using
Note 2: When using the VIA and VIB terminals as contact input terminals in sink logic connection, be sure to
Use the above parameters to send signals from an external programmable controller to various control
input terminals to operate and/or set the inverter.
The desired contact input terminal functions can be selected from 65 types (0-64). This gives system
design flexibility. (Note, however, for
functions (5 - 17).)
Note that the setting 52 (forced operation) can be enabled only when the inverter is so configured at
the factory. For more information, contact your local Toshiba dealer.
The functions of the VIB and VIA terminals can be selected between analog input and contact input by
changing parameter settings
To use the VIA and VIB terminals as contact input terminals, you need to set
to 4) that suits your needs, since analog input (voltage signal input) is assigned to the terminals by
default.
Title
- Always-active function selection
F Input terminal selection 1 (F)
R Input terminal selection 2 (R)
RES Input terminal selection 3 (RES)
S1 Input terminal selection 4 (S1)
S2 Input terminal selection 5 (S2)
S3 Input terminal selection 6 (S3)
is set to 1-4, the following terminals are
VIB Input terminal selection 7 (VIB)
VIA Input terminal selection 8 (VIA)
always activated.
insert a resistor between the P24 terminal and the VIA/VIB terminals. (Recommended resistance:
4.7kΩ-1/2W)
Be sure to turn the VIA slide switch to the V position.
and , a function can be selected from among 13
.
Function Adjustment range
(See section 11, K-
5-17 (Note 2)
(always-active function selection parameter) is
F-8
E6581158
to the number (1
Default setting
1 (ST)
2 (F)
3 (R)
0-64
10 (RES)
15-17)
6 (SS1)
7 (SS2)
8 (SS3)
- -
9 (SS4)
5 (AD2)