Toshiba TOSVERT VF-S11 Instruction Manual page 115

Setting of output terminal function
Terminal
Title
symbol
RY-RC Output terminal selection 1A
OUT-NO Output terminal selection 2A
FL (A,B,C) Output terminal selection 3
RY-RC Output terminal selection 1B
OUT-NO Output terminal selection 2B
RY-RC/
Output terminal logic selection
OUT-NO
Two different functions can be assigned to the output terminals (RY-RC and OUT-NO), and two logics with
different functions can be selected using
The logical product (AND) or logical sum (OR) of the two functions assigned is put out as a signal, depending
on the setting of parameter
If = , the logical sum (AND) of
The logical product (OR) of
If = , the logical product (OR) of
The logical sum (AND) of
If = , the logical sum (AND) of
The logical product (OR) of
If = , the logical product (OR) of
The logical product (OR) of
To assign only one function to output terminals, assign the function to
to as they are set by default.
Function
0 :
1 :
2 :
3 :
.
.
and will be output to RY-RC.
and
and will be output to RY-RC.
and will be output to OUT-NO.
and will be output to RY-RC.
and
and will be output to RY-RC.
and
F-13
Adjustment range Default setting
4 (Low-speed
detection signal)
6 (Designated
frequency reach)
0-255
10 (Failure FL)
(See Section 11)
255 (Always
255 (Always
and
and
or
and
and
or
or
or
will be output to OUT-NO.
will be output to OUT-NO.
will be output to OUT-NO.
and while leaving
E6581158
active)
active)
0
6