Toshiba TOSVERT VF-S11 Instruction Manual page 237

Communication
Title Function
No.
0619 Over-torque
detection level
hysteresis
0621 Cumulative
operation time
alarm setting
0626 Over-voltage stall
protection level
0627 Undervoltage
trip/alarm
selection
0633 Trip at VIA low
level input mode
0634 Annual average
ambient
temperature
(calculation for life
alarms)
• Output parameters
Communication
Title Function
No.
0669 Logic output/pulse
train output
selection (OUT-
NO)
0676 Pulse train output
function selection
(OUT-NO)
0677 Maximum nembers
of pulse train
0691 Inclination
characteristic of
analog output
0692 Meter bias
*1 : Default values vary depending on the capacity. See the table of K-14.
Minimum
setting unit
Unit Adjustment range
Panel/Commun
ication
% 1/1 0-100
100 0.1/0.1 0.0-999.9
Time (=10 hours)
1/1 100-150
%
- - 0: Alarm only
(detection level below 60%)
1: Tripping
(detection level below 60%)
2: Alarm only
(detection level below 50%,
DC reactor necessary)
1/1 0: Disabled, 1-100
- - 1: -10 to +10 C
2: 11-20 C
3: 21-30 C
4: 31-40 C
5: 41-50 C
6: 51-60 C
Minimum
setting unit
Unit Adjustment range
Panel/Commun
ication
- - 0: Logic output
1: Pulse train output
- - 0: Output frequency
1: Output current
2: Set frequency
3: DC voltage
4: Output voltage command value
5: Input power
6: Output power
7: Torque
8: Torque current
9: Motor cumulative load factor
10: Inverter cumulative load factor
11: PBR (braking reactor) cumulative
load factor
12: Frequency setting value (after
PID)
13: VIA/II Input value
14: VIB Input value
15: Fixed output 1 (Output current:
100%)
16: Fixed output 2 (Output current:
50%)
17: Fixed output 3
(Other than the output current:
100%)
pps 1/1 500-1600
- - 0: Negative inclination (downward
slope)
1: Positive inclination (upward slope)
% 1/1 0 100
K-11
E6581158
Default User
Reference
setting setting
10 6.19.9
610 6.19.10
*1 6.13.5
0 6.19.12
0 6.19.13
3 6.19.14
Default User
Reference
setting setting
0 6.20.1
0 6.20.1
800 6.20.1
1 6.20.2
0 6.20.2
11