Toshiba TOSVERT VF-S11 Instruction Manual page 123

E6581158
<<Sample sequence diagram 1: Adjustment with continuous signals>>
RUN command
Incrementing (UP) signal
Decrementing (DOWN) signal
Set frequency clearing signal
Upper limit frequency
Gradient
Gradient
Designated frequency (Hz)
Lower limit frequency
Frequency 0Hz
The dotted lines represent effective output frequencies.
Adjustment with pulse signals (Parameter-setting example 2)
Set parameters as follows to adjust the frequency in steps of one pulse:
6
, Pulse On time
, = Frequency obtained with each pulse
* The inverter does not respond to any pulses with an ON time shorter than that set with or
. 12ms or more of clearing signal is allowed.
F-21