Toshiba TOSVERT VF-S11 Instruction Manual page 56

3.1.1 How to start and stop
[Example of a setting procedure]
Key operated LED display
MODE
⇔
(1) Start and stop using the operation panel keys (
Use the and
: Motor starts.
: Motor stops.
(2) RUN/STOP by means of an external signal to the terminal board (
Sink logic
Use external signals to the inverter terminal board to start and stop the motor.
Short and terminals: run forward
CC
Open and terminals: slow down
F CC
and stop
Frequency
F-CC
Displays the operation frequency (operation stopped).
(When standard monitor display selection
frequency])
Displays the first basic parameter [History (
Press either the or
Press ENTER key to display the parameter setting. (Default setting: ).
Change the parameter to
Press the ENTER key to save the changed parameter.
parameter set value are displayed alternately.
keys on the operation panel to start and stop the motor.
* Coast stop
The standard default setting is for slowdown
stop. To make a coast stop, assign a "1(ST)"
terminal function to an idle terminal using the
programmable terminal function.
Change to
For coast stop, open the ST-CC when stopping
the motor in the state described at left.The
Slow down and
monitor on the inverter at this time will display
stop
ON
OFF
C-3
Operation
=
)].
key to select " ".
(terminal board) by pressing the
= )
= .
.
Coast stop
Motor
speed
F-CC
ST-CC
E6581158
[Operation
3
key.
and the
= ):
ON
OFF
ON
OFF