Toshiba TOSVERT VF-S11 Instruction Manual page 35

• Avoid operation in any location where there is direct spraying of the following solvents or other chemi-
cals. The plastic parts may be damaged to a certain degree depending on their shape, and there is a
possibility of the plastic covers coming off and the plastic units being dropped. If the chemical or sol-
Prohibited
vent is anything other than those shown below, please contact us in advance.
(Table 1) Examples of applicable chemicals
and solvents
Chemical
Hydrochloric acid
(density of 10% or less)
Sulfuric acid
(density of 10% or less)
Nitric acid
(density of 10% or less)
Caustic soda
Ammonia
Sodium chloride (salt)
Note:
•
Operate in areas where ambient temperature ranges from -10°C to 60°C. Operation over 40°C is al-
lowed when peel off the top warning label. When installing the inverter where the ambient temperature
will rise above 50°C, remove the caution label (seal) from the top of it and operate it at a current lower
than the rated one.
Note: The inverter is a heat-emitting body. Make sure to provide proper space and ventilation when install-
ing in the cabinet. When installing inside a cabinet, we recommend peel of the top seal although
40°C or less.
Warning
Solvent
Methanol
Ethanol
Triol
Mesopropanol
Glycerin
The plastic cover has resistance to deformation by the above applicable solvents. They are
not examples for resistance to fire or explosion.
•
Do not install in any location of high temperature, high humidity,
moisture condensation and freezing and avoid locations where
there is exposure to water and/or where there may be large
amounts of dust, metallic fragments and oil mist.
•
Do not install in any location where corrosive gases or grinding
fluids are present.
5cm
A-23
(Table 2) Examples of unapplicable
chemicals and solvents
Chemical Solvent
Phenol Gasoline,
kerosene, light oil
Benzenesulfonic Turpentine oil
acid
Benzol
Thinner
5cm
Measurement position
Measurement position
E6581158
1