Toshiba TOSVERT VF-S11 Instruction Manual page 244

Table of output terminal functions 2
Function
No.
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
11
27
28
29
30
31
32
33
34
Code
OT Over-torque detection
OTN Inversion of over-torque detection
RUN Start/Stop
RUNN Inversion of RUN/STOP
POL OL pre-alarm
POLN Inversion of OL pre-alarm
POHR Braking resistor overload pre-alarm
POHRN Inversion of braking resistor overload pre-alarm
POT Over-torque detection pre-alarm
POTN Inversion of over-torque detection pre-alarm
PAL Pre-alarm
PALN Inversion of pre-alarm
UC Small-current detection
UCN Inversion of small-current detection
HFL Significant failure
HFLN Inversion of significant failure
LFL Insignificant failure
LFLN Inversion of insignificant failure
RDY1 Ready for operation (including ST/RUN)
RDY1N Inversion of ready for operation (including
ST/RUN)
RDY2 Ready for operation (excluding ST/RUN)
RDY2N Inversion of ready for operation (excluding ST/RUN)
FCVIB Frequency VIB selection
Function
ON: Torque current is equal to or larger than
OFF: The torque current is equal to or less than
Inversion of OT
ON: When operation frequency is output or during
OFF: Operation stopped
Inversion of RUN setting
ON: 50% or more of calculated value of overload
OFF: Less than 50% of calculated value of
Inversion of POL setting
ON: 50% or more of calculated value of
OFF: Less than 50% of calculated value of
Inversion of RCHR setting
ON: Torque current is equal to or larger than 70%
OFF: The torque current is below (
Inversion of POT setting
One of the following is turned on:
All the following are turned off:
Inversion of PAL setting
ON: The output current is equal to or less than
OFF: The output current is equal to or larger than
Inversion of UC setting
ON:
OFF: Failure other than the above
Inversion of HFL setting
ON: (
OFF: Failure other than the above
Inversion of LFL setting
ON: Ready for operation (ST and RUN are also
OFF: Others
Inversion of RDY1 setting
ON: Ready for operation (ST and RUN are not
OFF: Others
Inversion of RDY2
ON: VIB selected as frequency command
OFF: Terminal other than VIB selected as
K-18
E6581158
Action
set value and longer than
set time.
( set value - set value).
( )
protection level
overload protection level
set overload protection level
set overload protection level
of set value.
value x 70% - set value).
ON POL, POHR, POT, MOFF, UC, OT, LL
stop, CCT, and momentary power failure
slowdown stop.
or , , issues an alarm
OFF POL, POHR, POT, MOFF, UC, OT, LL
stop, CCT, and momentary power failure
slowdown stop.
or , , issues no alarm
set value for set time.
set value + 10%.
, , , ,
, , ,
, , , ,
, )
- , - , ,
- , )
ON)
ON)
frequency command
set
-
,