Toshiba TOSVERT VF-S11 Instruction Manual page 201

Note 1: Press the or
Note 2: You can switch between % and A (ampere)/V (volt), using the parameter
selection).
Note 3: The input (DC) voltage displayed is 1 2 times as large as the rectified d.c. input voltage.
Note 4: The number of bars displayed varies depending on the setting of
tion selection). The bar representing VIA or VIB is displayed only when the logic input function is as-
signed to the VIA or VIB terminal, respectively.
If = : Neither the bar representing VIA nor the bar representing VIB is displayed.
If = or : The bar representing VIA is not displayed.
If = or : Both the bar representing VIA and VIB are displayed.
Note 5: The number of bars displayed varies depending on the setting of
selection). The bar representing the OUT-NO terminal is displayed only when logic output function is as-
signed to it.
If = : The bar representing OUT-NO is displayed.
If = : The bar representing OUT-NO is not displayed.
Note 6: The integrated amounts of input and output power will be reset to zero, if you press and hold down the
key for 3 seconds or more when power is off or when the input terminal function CKWH (input
terminal function: 51) is turned on or displayed.
Note 7: If there is no trip record,
Note 9: The cumulative operation time increments only when the machine is in operation.
key to change items displayed in the status monitor mode.
The bar representing VIB is displayed.
is displayed.
H-5
E6581158
(current/voltage unit
(analog input/logic input func-
(logic output/pulse train output
8