Toshiba TOSVERT VF-S11 Instruction Manual page 243

Table of input terminal functions 3
Function
Code
No.
54 STN Inversion of ST (coasting)
55 RESN Inversion of RES
56 F+ST Combination of forward run and standby
57 R+ST Combination of reverse run and standby
58 AD3 Acceleration/deceleration 3 selection
59 F+AD3 Combination of forward run and
acceleration/deceleration 3
60 R+AD3 Combination of reverse run and
acceleration/deceleration 3
61 OCS2 Forced switching of stall prevention level 2
62 HDRY Holding of RY-RC terminal output
63 HDOUT Holding of OUT-NO terminal output
64 PRUN Cancellation (clearing) of operation command from
panel
Table of output terminal functions 1
Function Code
No.
0 LL Frequency lower limit
1 LLN Inversion of frequency lower limit
2 UL Frequency upper limit
3 ULN Inversion of frequency upper limit
4 LOW Low-speed detection signal
5 LOWN Inversion of low-speed detection signal
6 RCH Designated frequency attainment signal
(completion of acceleration/deceleration)
7 RCHN Inversion of designated frequency attainment
signal (inversion of completion of
acceleration/deceleration)
8 RCHF Set frequency attainment signal
9 RCHFN Inversion of set frequency attainment signal
10 FL Failure signal (trip output)
11 FLN Inversion of failure signal (inversion of trip output)
Function
ON: Coast stop (gate off)
OFF: Ready for operation
ON: Acceptance of reset command
OFF→ ON: Trip reset
ON: Simultaneous input from F and ST
ON: Simultaneous input from R and ST
ON: Acceleration/deceleration 3
OFF: Acceleration/deceleration 1 or 2
ON: Simultaneous input from F and AD3
ON: Simultaneous input from R and AD3
ON: Enabled at the value of
OFF: Enabled at the value of
ON: Once turned on, RY-RC are held on.
OFF: The status of RY-RC changes in real time
ON: Once turned on, OUT-NO are held on.
OFF: The status of OUT-NO changes in real time
0: Operation command canceled (cleared)
1: Operation command retained
Function
ON: The output frequency is above the
OFF: The output frequency is equal to or less than
Inversion of LL setting
ON: Output frequency is equal to or higher than
OFF: Output frequency is lower than
Inversion of UL setting
ON: Output frequency is equal to or higher than
OFF: Output frequency is lower than
Inversion of LOW setting
ON: The output frequency is equal to or less than
OFF: The output frequency is above the specified
Inversion of RCH setting
ON: The output frequency is equal to or less than
OFF: The output frequency is above the frequency
Inversion of RCHF setting
ON: When inverter is tripped
OFF: When inverter is not tripped
Inversion of FL setting
K-17
E6581158
Action
according to conditions.
according to conditions.
Action
value.
the set value.
value.
value.
value.
the specified frequency ± frequency set with
.
frequency ± frequency set with
the frequency set with ± frequency
set with .
set with ± frequency set with
.
set
value.
11
.