Connection Type - Icom VE-PG2 Instruction Manual

t Connection type
Set the signal timing to, and the receive timing from, the [TRX1]–[TRX3] ports.
( Default: AF input detection when Multicast mode is selected, Always-on connection
when Unicast mode is selected.)
• AF input detection
• Always–on connection
• Transmit only
• Receive only
[NOTE]
If you set "IP communication mode setting" to "Unicast mode," the "IP network con-
nection setting" information is displayed as shown below.
BRIDGE MODE SETTING SCREEN
: The [TRX1]–[TRX3] ports are connected to the IP network to
send/receive signals when the VE-PG2 detects an audio signal.
: The [TRX1]–[TRX3] ports are always connected to the IP network
to send/receive signals.
• You can select "Always–on connection" when the VE-PG2 is in
the "Unicast mode."
• The VE-PG2 outputs no audio signals while the [TRX1]–[TRX3]
ports detect no signal.
: Ports [TRX1]–[TRX3] are always connected to the IP network to
send signals.
• The VE-PG2 outputs no audio signals while the [TRX1]–[TRX3]
ports detect no signal.
• The [TRX1]–[TRX3] ports outputs no audio signal if the VE-PG2
receive audio signals from IP network.
: The [TRX1]–[TRX3] ports send audio signal while the VE-PG2
receive audio signals from IP network.
• The VE-PG2 outputs no audio signal to the IP network if ports
[TRX1]–[TRX3] receive audio signals from the connected
transceivers.
4
1
2
3
4
5
6
7
8
9
10
11
127