Icom VE-PG2 Instruction Manual page 278

6
CONVERTER MODE SETTING SCREEN
■ Connection setting
6-9 TRX/EXT EXT output
ï EXT voice terminal setting (Continued)
Place the mouse pointer on "Connection setting," and then on "TRX/EXT," and then
click "EXT Output (EXT OUT)" shown on the list.
q
w
e
r
e Fade-out
Set the time until the AF signal is muted.
(Default: 1.5 seconds)
Selectable from Disable, 0.5, 1, 1.5, 2 or 3.
Set the delay time from when a DTMF signal is received by the VE-PG2, until it
gradually decreases the currently broadcast audio, that is sent to the [OUT] port
until no sound is heard.
• Set "EXT I/O port" to "Separate mode."
• Set "Input connection port" to "EXT Output." (p. 272)
• Set "Priority level setting" to "Priority calling" or "High priority calling."
• Fade-out is not used before an emergency broadcast is sent.
• This item appears only when you select "Separate mode" in "EXT I/O port" in "Operating
mode."
r Fade-in
Set the time until the mute is cancelled.
(Default: 1.5 seconds)
Selectable from Disable, 0.5, 1, 1.5, 2 or 3.
Set the delay time from when a DTMF signal is received by the VE-PG2, until it
gradually increases the audio, that was sent through the [OUT] port, to its original
level.
• Set "EXT I/O port" to "Separate mode."
• Set "Input connection port" to "EXT Output." (p. 272)
• Set "Priority level setting" to "Priority calling" or "High priority calling."
• Fade-in is not used after an emergency broadcast is sent.
• This item appears only when you select "Separate mode" in "EXT I/O port" in "Operating
mode."
278