Emergency Notice - Icom VE-PG2 Instruction Manual

4
BRIDGE MODE SETTING SCREEN
■ Connection setting
4-1 Operating mode
ï IP communication mode setting (Continued)
Place the mouse pointer on "Connection setting," and then click "Operating mode"
shown on the list.
q
w
e
r
e EXT Output port (EXT OUT)
Set the communication mode of the [OUT] port to "Multicast mode" or "Unicast
mode."
(Default: Unicast mode)
• This menu is displayed only when you set "EXT I/O port mode setting" to "Separate mode."
[NOTE]
EXT I/O port (EXT) is displayed only when you set "EXT I/O port mode setting" to
"Combined mode."
Set the communication mode of the [OUT] ports to "Multicast mode" or "Unicast
mode." (Default: Unicast mode)
r Emergency notice
Set the communication mode of the emergency notice to "Multicast mode" or
"Unicast mode." (Default : Unicast mode)
• You can select any combination of the [TRX1]–[TRX3] ports, the [OUT] port and the
emergency notice equipment as the emergency notice signal sending ports. (p. 159)
[NOTE]
• When you set "IP communication mode setting" to "Multicast mode," you can send signals to
all transceivers or repeaters that are connected to the VE-PG2.
• When you set "IP communication mode setting" to "Unicast mode," you can send signals to
the specified transceiver or repeater that is connected to a specified VE-PG2.
124