Icom VE-PG2 Instruction Manual page 259

ï SIP server setting
Set the IP router settings to use transceivers that are connected to the emergency
device, when you select "SIP server transmit" in the "VoIP call destination setting."
Place the mouse pointer on "Connection setting," and then on "IP network connec-
tion," and then click "Emergency notice" shown on the list.
q
w
e
r
t
y
u
i
o
q IP phone number
Enter an IP phone number which calls to the transceivers that are connected to the
emergency notice.
Enter an IP phone number of up to seven numbers.
NOTE: Enter the same IP phone number in the IP router.
w Primary SIP server IP address
Enter the primary IP router's IP address, or host name, up to 63 characters.
e Secondary SIP server IP address
Enter a secondary IP router's IP address, or host name, of up to 63 characters.
When the primary IP router cannot receive the signals from the VE-PG2, the VE-
PG2 sends a signal to the secondary IP router.
NOTE: If the VE-PG2 receives no reply from the primary and secondary IP routers,
it repeatedly sends signals to them.
CONVERTER MODE SETTING SCREEN
6
1
2
3
4
5
6
7
8
9
10
11
259