Emergency Notice - Icom VE-PG2 Instruction Manual

4-11 Emergency notice

ï Emergency notice setting
Set the emergency notice output ports when the audio signal is input to the [IN]
port or calling to setting port which is set at "IP network connection setting" in the
"Emergency notice" on the "Connection setting–IP network connection."
Place the mouse pointer on "Connection setting," and then click "Emergency notice"
shown on the list.
q
w
e
r
t
q Transceiver 1 (TRX1)
If you click the "Transceiver 1 (TRX1)" check box, the VE-PG2 sends the emergency
notice to the [TRX1] port.
(Default: o Transceiver 1 (TRX1))
w Transceiver 2 (TRX2)
If you click the "Transceiver 2 (TRX2)" check box, the VE-PG2 sends the emergency
notice to the [TRX2] port.
(Default: o Transceiver 2 (TRX2))
e Transceiver 3 (TRX3)
If you click the "Transceiver 3 (TRX3)" check box, the VE-PG2 sends the emergency
notice to the [TRX3] port.
(Default: o Transceiver 3 (TRX3))
r EXT Output
If you click the "EXT Output" check box, the VE-PG2 sends the emergency notice to
the external device which is connected to the [OUT] port.
(Default: o EXT Output)
• This is not displayed when "Combined mode" is selected in "EXT I/O port mode setting."
t Emergency notice equipment
If you click the "Emergency notice equipment" check box, the VE-PG2 sends the
emergency notice to the transceiver or external device that is connected to the
VE-PG2.
(Default: o Emergency notice equipment)
• The device can be set by the "IP Communication setting" in "IP Communication–Emergency
notice."
• You can transmit or send the emergency notice only when "Emergency" is set at the "Input
connection port" in "TRX/EXT–EXT Input(EXT IN)."
BRIDGE MODE SETTING SCREEN
4
1
2
3
4
5
6
7
8
9
10
11
159